1068650 Kenmore Refrigerator Parts List

Search the entire 1068650 by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Capacitor (running capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Easy Part #:: EAP11757023

Availability:: In Stock

Price:: $90.79

Refrigerator door switch (switch, rocker arm)

Door switch turns the light off when you close the door.

Easy Part #:: EAP12728638

Availability:: In Stock

Price:: $44.14

Defrost timer (timer, defrost (10 hour))

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Easy Part #:: EAP11723171

Availability:: In Stock

Price:: $39.78

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:: EAP385132

Availability:: In Stock

Price:: $9.20

Condenser fan motor kit (fan, motor)

This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Easy Part #:: EAP395284

Availability:: In Stock

Price:: $78.17

Hinge bracket (door bracket)

This part is used to support the hinge.

Easy Part #:: EAP11739061

Availability:: In Stock

Price:: $12.33

Icemaker control assembly (module, assembly)

This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. It also controls the heater, the water inlet valve, the cube size, and cube ejection. The control assembly is located under the white cover of the ice maker. If the ice maker is making too much ice or not making ice at all, you may need to replace the control assembly. The motor is not sold separately. This is a genuine OEM part. Please make sure you disconnect power to the refrigerator before starting your repair.

Easy Part #:: EAP2341896

Availability:: In Stock

Price:: $136.20

Bimetal defrost thermostat (heater, defrost)

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

Easy Part #:: EAP11742474

Availability:: In Stock

Price:: $48.83

Refrigerator single water inlet valve (valve, solenoid)

The single water inlet valve is used to supply water to the water dispenser and the ice maker. The valve is 60Hz 120 Volts and 35 watts. If your ice maker isn’t producing ice or the water dispenser not dispensing water, the solenoid might have gone bad and will need to be replaced. This valve includes 1/4” tubing and a plastic union. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the refrigerator before starting the repair.

Easy Part #:: EAP11740365

Availability:: In Stock

Price:: $82.14

Screw

Sold individually.

Easy Part #:: EAP11743743

Availability:: In Stock

Price:: $6.23

Door shelf end cap set (end cap, trim (4))

This door shelf end cap set contains two white end caps. Each end cap can be used as either the right or the left side. These end caps also come with adhesive strips and an instructions sheet.

Easy Part #:: EAP370794

Availability:: In Stock

Price:: $20.99

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Easy Part #:: EAP11756735

Availability:: In Stock

Price:: $88.52

Evaporator fan motor kit (motor evaporator)

The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.

Easy Part #:: EAP376645

Availability:: In Stock

Price:: $85.16

Ice maker water fill tube kit (fitting, water tube)

The ice maker fill tube is used to supply water to the ice maker during the fill cycle and is located in the back wall of your refrigerator/freezer. The fill tube is 10” long and includes a compression nut and a tube insert. If the fill tube is cracked or leaking water you will need to replace it. This part is white in color, made of plastic, and is a genuine OEM part. Please remember to disconnect the power and shut off the water supply before starting your repair.