11026955690 Kenmore Washer Parts List

Search the entire 11026955690 by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Agitator directional cogs (dog, agitator (clutch)(4))

These agitator directional cogs are commonly referred to as dog ears. They come four in a package and are usually used with direct drive washing machines. When the teeth on the outer edge are worn down the cogs will not engage with the upper agitator, causing it not to agitate properly. It is recommended to replace all four at the same time. These agitator directional cogs are ?-inch high and 1-inchlong and they are a genuine OEM part.

Easy Part #:: EAP388034

Availability:: In Stock - Ships Today

Price:: $4.93

Direct drive motor coupling (coupling, motor and isolation)

The newer version of the coupler kit is made with new metal sleeves for added strength. This part is located between the motor and transmission on the direct drive washer that does not have a belt. The coupler will break to protect the motor from damage if the drive motor system seizes up. If your washer will not fill, will not agitate or spin, but it will drain the water from the tub, you may need to replace this part because it has failed. This is a genuine OEM part. Disconnect the power to your washer before starting the repair.

Easy Part #:: EAP1485646

Availability:: In Stock - Ships Today

Price:: $32.01

Clutch assembly (clutch (complete))

The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.

Easy Part #:: EAP334641

Availability:: In Stock - Ships Today

Price:: $34.27

Suspension spring (spring, suspension (3))

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be off balance and noisy. Check your model to see how many springs are required for your model. The spring is sold individually.

Easy Part #:: EAP11743345

Availability:: In Stock - Ships Today

Price:: $9.19

Lid switch assembly (switch, lid)

This part comes with a three-wire lead. The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.

Easy Part #:: EAP11742021

Availability:: In Stock - Ships Today

Price:: $59.58

Tub spring (spring, counterweight)

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be noisy and off balance during the spin cycle. Please check your model to see how many springs are required for your model. The spring is sold individually. This is a genuine OEM part. Please make sure you disconnect the power to the washer before starting your repair.

Easy Part #:: EAP11751118

Availability:: In Stock - Ships Today

Price:: $8.09

Centerpost gasket (gasket, center post)

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

Easy Part #:: EAP11723081

Availability:: In Stock - Ships Today

Price:: $6.61

Tub wear pads - package of 3 (pad, base)

This package of pads contains three tub wear pads.

Easy Part #:: EAP334620

Availability:: In Stock - Ships Today

Price:: $19.36

Direct drive water pump (pump (complete))

This white direct drive drain pump is intended for use with washing machines that do not have belts. This pump has a backflow flapper valve, and two large ports for water to pass through.

Easy Part #:: EAP11741242

Availability:: In Stock - Ships Today

Price:: $82.77

Drain hose (connector-drain hose)

It connects from the pump to the back panel. The clamp is not included.

Easy Part #:: EAP11753688

Availability:: In Stock - Ships Today

Price:: $44.72

Suspension spring retainer (retainer, suspension spring (3))

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Easy Part #:: EAP11749057

Availability:: In Stock - Ships Today

Price:: $8.49

Washer

This part goes on the agitator retaining bolt.

Easy Part #:: EAP11742027

Availability:: In Stock - Ships Today

Price:: $8.84

Drive block - 2 5/16 inch high (block, basket drive)

This part is for large capacity belt drive and direct drive appliances.

Easy Part #:: EAP11741977

Availability:: In Stock - Ships Today

Price:: $27.30

Gearcase (gearcase (complete))

This is used in your direct drive washer that has a neutral drain.

Easy Part #:: EAP341974

Availability:: In Stock - Ships Today

Price:: $436.12

Hose clamp (clamp, hose)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.