1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
Metallic screw that is less than an inch long. Does not include the plastic washer.
The wire kit attaches to the cutter grid frame. The wire is used to cut the ice slab into cubes. There is approximately 10 feet of wire. Note: 2 kits are needed to replace both directions. This is a genuine OEM kit. It is recommended to disconnect power to the appliance before starting the repair.
This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.
This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. This kit includes the compressor, grommets, drier tube, overload, start relay, run capacitor, wire and terminal cover.
The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.
Also known as evaporator control thermostat - used for stand-alone ice makers.
Used on freestanding ice makers.
Used in stand-alone ice makers. The cycling thermostat controls the activation of the icemaker ejection cycle.
Covers Relay/Overload on the Compressor