DBLR453GT0AA Dryer Parts List

Search the entire DBLR453GT0AA by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

M series new style coil kit

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:: EAP334310

Availability:: In Stock

Price:: $35.48

D-shaped knob clip (u clip)

This control knob clip helps secure the timer knob to the shaft allowing you to select the desired setting for your dryer. If the knob has become loose or the clip is missing you will need to replace the clip. This clip is a genuine OEM part, made of metal and is sold individually.

Easy Part #:: EAP268493

Availability:: Special Order

Price:: $9.83

Door latch (latch door)

This part helps to keep the door closed while the machine is running.

Easy Part #:: EAP3502777

Availability:: Special Order

Price:: $13.07

Rotary start switch (switch rotary start)

This part is used to start the dryer once you have selected a setting on the timer.

Easy Part #:: EAP268305

Availability:: Special Order

Price:: $91.98

Drum slide (bearing, slide)

This slide is sold individually. Some dryers require up to three of these slides . Be sure to check to make sure you order the necessary amount for your dryer.

Easy Part #:: EAP267877

Availability:: Special Order

Price:: $16.40

Rear drum bearing kit (shaft & bracket asm)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Easy Part #:: EAP267529

Availability:: No Longer Available

Drive belt (belt drive)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Easy Part #:: EAP2350043

Availability:: Special Order

Price:: $51.97

Adjustable leveling screw (screw levelling 5/16-24)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Easy Part #:: EAP1021358

Availability:: Special Order

Price:: $9.97

Door strike (strike door)

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the door will not lock properly and not only will this cause the door to swing open, but it won’t allow the dryer to start properly. It is a small piece of metal, about 1 inch in length and is sold individually.

Easy Part #:: EAP266893

Availability:: Special Order

Price:: $9.81

Selector knob with clip (knob & clip asm ad)

This knob accepts a D-shaped shaft. Sold individually.

Easy Part #:: EAP271094

Availability:: No Longer Available

M-series primary dual coil gas valve (coil dual)

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

Easy Part #:: EAP268153

Availability:: Special Order

Price:: $74.49

Idler pulley wheel (pulley idler)

The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.