1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
This part helps to keep the door closed while the machine is running.
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.
This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.
This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.
This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.
This wheel attaches to the motor.
This restring coil kit is used to replace the existing coil in a dryer's heating element.
Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.
With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)
At just under three inches, this metal spring fits onto the arm of the idler pulley assembly of many of GE's clothes dryers. It provides for the tension needed in the belt by keeping the idler snug and stable.
This front drum slide kit comes with two slides with the apppropriate mounting hardware.