LDF6920ST LG Dishwasher Parts List

Connector assembly

The door hinge cable works in conjunction with the dishwasher door by connecting the door hinge to the door spring and helping to support and balance the weight of the door as you open and close it. If your dishwasher door isn’t closing properly you will need to replace this part. This part measures approximately 12” and is black and white in color. This is a genuine OEM part.

Roller with axle (roller assembly)

The rack roller with axle attaches to the upper rack to allow you to move the dishrack in and out with ease along the support rails. The rollers and axles sometimes wear out at the same rate and the manufacturer recommends replacing the axles in pairs. This part is gray in color, made of plastic, and measures 1 1/2” wide. This is a genuine OEM part and is sold individually.

Roller assembly

The lower rack roller and axle attaches to the rack and allows you to slide the lower dish rack in and out smoothly. If a roller becomes damaged or broken it will need to be replaced. This part measures approximately 2 1/2” in diameter, gray in color, made from plastic, and is sold individually. This is a genuine OEM part.

Spring,hinge

The door spring is used to help support and balance the weight of the dishwasher door as it open and closes. The door hinge measures a little over 10” long and made of metal. If the dishwasher door feels heavy, or is noisy when opening or closing , you may need to replace this part. This is a genuine OEM part and is sold individually.

Pump gasket (packing)

The pump gasket is used to prevent water from leaking between the filter and pump housing. The pump gasket helps seal the impeller allowing to maintain the water pressure in the spray arms. If the gasket breaks it will cause water to leak and your dishes won’t be properly cleaned which will result in dirty dishes. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Filter assembly,mesh

The circulation pump mesh filter is used in your dishwasher to avoid food particles from entering the pump during the wash cycle and prevent the pump from getting clogged. The filter also helps support the lower spray arm. If the mesh filter gets torn or clogged beyond cleaning, it will cause the dishwasher to have dirty water or low water pressure and will need to be replaced. The filter measures 10” in diameter. This is a genuine OEM part. Please remember to shut off the power and water supply before starting the repair.

Diverter motor - 120v 60hz (motor assembly,ac,drain)

The diverter motor works in conjunction with the spray arms in your dishwasher by controlling the flow of water to the spray arms. The motor turns the check valve inside the pump to avert the flow of water between the drain pump and the spray arms. If the motor fails it will cause the dishwasher not to wash or drain and will need to be replaced. This diverter motor is 120 volts and 60 Hz. Please remember to disconnect the power and water supply to the dishwasher before starting the repair. This is an authorized OEM part.

Door gasket - black (packing)

Hose assembly, drain (hose assembly,drain)

This replacement dishwasher drain hose connects the drain pump to the air gap or the garbage disposal to drain the water from the dishwasher. The hose is gray in color and made of plastic. If the drain hose becomes cracked or damaged it will cause a water leak and will need to be replaced. This is a replacement drain hose from the manufacturer. The manufacturer advises that if the drain hose that is being replaced does not have the vent tube going to the water inlet assembly, a new water inlet will need to be purchased. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Basket assembly,spoon

Tub seal (packing)

Sump assembly

Water inlet valve (valve assembly,inlet)

Noise filter assembly (filter assembly)

Shaft,nozzle