LMV1545SW LG Microwave Parts List

Search the entire LMV1545SW by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Micro switch (microwave door switch. This switch is normally open. When the microwave door is shut, the door switches close to send power to the microwave.)

The microwave primary door switch, also known as a micro switch, is normally open. When the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed, and the part will need to be replaced. The micro switch is in the latch board section and monitors the position of the door. This part measures 1.5” L x .75” W NOTE: Due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge, even when unplugged. It is suggested to have a service technician install the part. This is a genuine OEM part. Please disconnect the power to the microwave before beginning the repair.

Easy Part #:: EAP3522738

Availability:: In Stock - Ships Today

Price:: $16.59

Charcoal filter (charcoal air filter. 2-1/2 inches by 11-1/4 inches. Replace yearly.)

This is an authentic LG charcoal filter for your microwave, sourced directly from the manufacturer. It is designed to remove odors from the air that circulate through your microwave vent. It measures approximately 11 inches in length, and 2.5 inches in width.

Easy Part #:: EAP3527523

Availability:: In Stock - Ships Today

Price:: $48.13

Light bulb - 120v 30w (microwave light bulb. The bulb operates on 120 volts and uses 30 watts.)

This 30 watt 120 volt incandescent light bulb, with a small screw base is used to light up the surface below your microwave or brighten the interior of the microwave once the door has been opened. If your light bulb is burnt out it will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. Remember to disconnect the power to the microwave before you begin this repair. This is a genuine OEM part and is sold individually.

Easy Part #:: EAP3530415

Availability:: In Stock - Ships Today

Price:: $18.34

Air duct bracket (air duct frame)

This bracket holds the metal or plastic flapper that closes off the exhaust duct when the fan is not running and opens when the fan turns on. If the exhaust fan on your microwave does not appear to be working, the problem may be with the damper assembly. If the damper does not open and close easily, check for any damage to the bracket, and replace if it is damaged or faulty. This genuine OEM exhaust damper measures approximately 12 inches long by 5 inches wide.

Easy Part #:: EAP3523851

Availability:: In Stock - Ships Today

Price:: $24.39

Damper (vent damper flap)

The vent damper is used to close off the exhaust duct when the fan is not running, to prevent outside air from entering the microwave. When the fan turns on it allows air to vent away from the microwave. The damper measures approximately 10-inch long by 3-inchwide and is a genuine OEM part.

Easy Part #:: EAP3524148

Availability:: In Stock - Ships Today

Price:: $16.17

Holder assembly,locker (latch board and door switch assembly.)

Easy Part #:: EAP3519053

Availability:: In Stock - Ships Today

Price:: $49.92

Locker (door latch hooks)

Part subs to 4026W2A015A

Easy Part #:: EAP3522838

Availability:: On Order

Price:: $9.39

Spring

Easy Part #:: EAP3524607

Availability:: In Stock - Ships Today

Price:: $9.39

Plate,mount (microwave oven mounting bracket assembly.)

Easy Part #:: EAP3518617

Availability:: In Stock - Ships Today

Price:: $59.34

Motor, ac synchronous (turntable motor)

If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed through the bottom. The motor is normally held in place with a retaining screw and will have two wires attached to it as well. If the motor is making a grinding noise it will need to be replaced. If the motor does not turn, you can check for voltage or continuity with a multi-meter. Make sure the power is disconnected from your microwave before beginning this repair.